Triton 2000 table saw wood operating

Here is a fast video of a fundamental sliding table I knocked up for the Triton 2000 Workcentre. Its various to a normal sled which spans both sides of the blade. This one is created to work much like a large industrial Panel saw sliding table, ie you always work at one side of the blade. All this setup consists of is essentially 1 piece of 6mm MDF which is screwed to the table. 2 much more pieces of 6mm are fixed to the bottom of the sled itself which then hugs the piece on the table and travels along it. From memory, I could get about 600mm of cross cut length and it was very correct….enjoy